Laretti LR7500, Manual

Page: 11 / 40

11
ENGLISH
OPERATION OF THE KETTLE
1. To fill the kettle, remove it from the power base and open the lid by pressing the open lid
button, fill with the desired amount of water, and then close the lid. Alternatively, the kettle
may be filled through the spout. The water level should not exceed MAX mark or sit below
MIN level. Too little water will result in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before plugging the power outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Press corresponding button according to your desire,
the details of all the buttons refer to the above control panel. After pressing any button, the
corresponding indicator state refers to the above description on the section of control panel.
The kettle will start to operate. And the water temperature also refers to the above description
on the section of control panel.
NOTE: Ensure that the switch is free of obstructions and the lid is firmly closed,
the kettle will not turn off, if the switch is constrained or if the lid is opened.