3
Sonic Guard/USB Mat
Installation and Operation
Declaration of Conformity
Manufacturer’s Name: Larco, Division of ATEK Access Technologies
Manufacturer’s Address: 210 10th Ave. NE, Brainerd, MN 56401 USA declares that the product:
Product Name: Sonic Guard/USB Mat
Model Numbers: ALL
Conforms to the following Product Specifications:
EN 55024: 1998 + A1: 2001 + A2: 2003
Information Technology Equipment – Immunity Characteristics
Larco Sonic Guard/USB Mats are 100% inspected and tested to insure that each mat we produce complies with
our demanding quality standards.
Varuni Novick
President
(800) 523-6996
(218) 829-9797
Larco Sonic Guard/USB Mat FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not
cause harmful interference, and 2) this device must accept any interference received, including interference that may cause
undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an output on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for assistance