Lapple FIBRO FIBROTOR EM.NC Series, Assembly And Operation Manual

Page: 10 / 60

1 INTRODUCTION
1.4 APPLICABLE DOCUMENTS
FIBROTOR
10 | 60
1.4
Applicable documents
Along with this manual, other applicable documents are necessary for the safe
operation of the machine. The data in these documents must be observed.

Instruction for the assembly of a partly completed machine according to Gui deline
2006/42/EG

Electric diagram

Hydraulic diagram

Pneumatic diagram

Drawings
1.5
Structure
The structural design is characterised by a rigid mechanical structure. The basic
device is comprised of the housing, table top, bearings, cam drive, drive motor with
gears and holding brake. Horizontal and vertical use with several motor layouts is
possible.
Additional component assemblies are available if the structure is to be extended.
The rotary table may also be used as a built-in table.
1.5.1
Bearing
The bearing for the table top is large and is both axially and radially pretensioned. In
order to absorb large tilting moments, e.g. when the table top is in a vertical position,
the additional component assembly "reinforced table top bearing" is available.
1.5.2
Middle throughlet
The rotary table is delivered with a large clear middle throughlet.
1.5.3
Direction of rotation
The direction of rotation can optionally be to the left or right. Pendulum mode is
possible.
1.5.4
Service life
The arrangement is subject to a service life of MTTF = 20,000 h.
1.5.5
Cam drive
The operation is generated by the drive motor via the gearbox and the cam drive on
the table top. The cam rollers are pretensioned on both sides on the operating cam.