Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warning
Fixing Instructions
Specification
Voltage:
240V 50Hz
Lamp:
Max. 1 x 11W LED module
IP rating:
44
Make sure you have the following items which
are required to install this light fitting:
• Selection of cross and flat head screwdrivers.
• Electric drill and assorted drill bits.
• Wire strippers.
Decide on the position of the light fitting, or remove
existing light fitting.
Take a note of the position of the
electrical connections.
• Remove the two side screws
(A)
. Retain them for
refitting later. Use the fixing bracket
(B)
as a template,
mark the screw holes, and secure to the wall with
appropriate fixings
(C)
, making sure the bracket is
correctly aligned.
• Bring the mains cable through the rubber grommet.
Open the terminal block box and connect the house
wiring to the internal terminal block
(D)
– see expanded
wiring details below.
NOTE: This is a Class 1 product
and must be Earthed
. The cable entry grommet must
be securely in place to ensure that the water ingress
protection is maintained.
• Remember to close the terminal box cover once
complete and make sure the earth cable is securely
connected to the earth screw
(E)
marked .
• Secure the fitting over the bracket by using the screws
(A)
removed in Point 2.
• Turn on the power and test.
Installation
Kit Contents
This kit contains:
• Light fitting
• Fixing pack
A
C
B
D
This is a Class 1 product and must be earthed.
This product is only suitable for connection to a
240V~50Hz supply in accordance with current IEE
wiring regulations. It should be installed in accordance
with local building regulations.
This product is IP44 rated and is suitable for outdoor use.
Before installing your light fitting always switch off
the mains supply and remove the appropriate fuse
or switch off the appropriate circuit breaker before
commencing installation.
This product contains glass so care must be taken
when fitting or handling to prevent personal injury or
damage to the product. If replacing an existing fitting,
make a careful note of the connections.
This product is suitable for installation on surfaces
with normal flammability e.g. wood, masonry. It is not
suitable for use on highly flammable surfaces or in
flammable atmospheres.
Never put anything on the product or hang anything
on any part of this product.
This product contains non-replaceable LEDs.
If you are in any doubt about your competence please
consult a qualified electrician.
If any modification is made it will invalidate the warranty
and may render the product unsafe.
Keep children and animals away from the assembly area.
This fitting contains small parts that could cause
choking if swallowed.
Keep all plastic wrapping materials away from children
to avoid danger of suffocation.
Ensure that all packaging is disposed of carefully
and responsibly.
E