Lanzar VBD 1400, Owner'S Manual

Page: 8 / 12

8
• REMOTE SENSOR
Point the remote control handset to
the remote sensor
IR (23).
Press the function keys on the handset
to control the system.
• RESET
Reset button (25) is placed on the front
panel and must be activated with either
a ball point pen or thin metal object.
The reset button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If press RESET button (25), the
unit can’t work yet, please use a cotton
swab soaked in isopropyl alcohol to
clean the socket on the back of the
front panel.
RADIO OPERATION
• BAND SELECTION
At tuner mode, press LOU/BND button
(13) to select the desired band.
The reception band will change in the
following order:
• STATION SELECTION
Press TUNE/SKIP/TRACK button
(16) or TUNE/SKIP/TRACK button
(17) shortly to activate automatic seek
function. Press for several seconds
until
“MANUAL” appeared on the
display, the manual tuning mode is
selected.
+
-
+
-
FLAT CLASSICS POP M JAZZ DSP OFF
FM1 FM2 FM3 AM
For Electrical Volume:
By pressing
AUDIO ADJUST button
(11) or AUDIO ADJUST button (12),
it is possible to adjust the desired
sound quality.
For Digital Rotating Volume:
By rotating the knob (11&12) clockwise
or counter-clockwise, it is possible to
adjust the desired sound quality.
• LOUDNESS
Press LOU/BND button (13) to
increase bass output and display will
show
“LOUD” . Press it again to
release this function.
• SET THE CLOCK
Press and hold DISP button (15) until
the clock is shown on the display and
flashed. Then press the
TUNE/SKIP/
TRACK button (17) to change
hours or TUNE/SKIP/TRACK
button (16) to change minutes.
• SELECT MODE
Press MODE button (6) to choose
desired listening mode. (e.g. radio mode
to CD mode)
• SUBWOOFER
Press MODE/SW button (6) for several
seconds to toggle subwoofer output.
When subwoofer on, display will show
“Sub. W” . Press it again for several
seconds to release this mode.
• MUTE
Press MUT button (4) to silence the
receiver. Press it again to release the mode.
• VACUUM FLUORESCENT DISPLAY
Exhibit current frequency and activated
functions on the display (8).
• EQUALIZATION
Press EQ button (1) to turn on
equalization function and to select
desired audio mode. There are four
kinds of mode as below: