5
f e a t u r e s a n d s p e c i f i c a t i o n s
Adjustable Bass Boost
Frequency
Adjustable Bass Boost
Adjustable Q Control
Power Supply
Input Impedance
S/N ratio
Max Output Signal Level
Channel Separation
Distortion
Dimensions,WxDxH,inches
(millimeters)
40Hz-400Hz
0-18dB
2-20
10-16V DC, negative ground
10K Ohm
more than 85dB
7.0V RMS
60dB
less than 0.05%
6x10-11/16x1-3/4
(150 x 272 x 45)
1. PARAMETER "Q" SELECT 2-20
2. BASS BOOST FREQUENCY CONTROL
3. BASS BOOST LEVEL CONTROL
4. VARIABLE LINE OUTPUT LEVEL
CONTROL
5. VARIABLE INPUT LEVEL CONTROL
6. VARIABLE SUBWOOFER PHASE SHIFT
CONTROL 0-180
7. SUBWOOFER STEREO/MONO MODE
CONTROL
8.INPUT PORT
9.LINE OUT PORT
10.OUTPUT PORT
11.REMOTE CONTROL JACK
12.POWER TERMINALS
Allows independent continuous change of the boost frequency bandwidth (Q-factor) for
each band from Q=20 (Narrow bandwidth, steep slope) to Q=2 (Wide bandwidth, gentle
slope).
This control adjusts the bass boost frequency from 40Hz to 400Hz.
This control sets the subwoofer gain control.
Turning this control to adjust the output sensitivity of line out to match the input of additional
amplifier, crossover or audio system.
Turning this control to adjust the input sensitivity of the set to match the radio's output.
Allows you to control the phase of your subwoofer between 0 degrees and 180 degrees to
help compensate for timing difference between drivers.
Allows you to control the subwoofer output between stereo and mono, thus facilitating single
subwoofer installation.
To be connected to the outputs of the source unit or signal processor.
To input additional amplifiers, crossover or Audio system.
To be connected to the amplifier left/right inputs.
Plug the modular telephone style cord connected to the remote control unit into this jack.
Use these connectors to deliver power, ground, and remote turn-on control to the unit.
REMOTE CONTROL UNIT
1.Q SELECT
This control will narrow or widen the boost frequency bandwidth (Q=factor) being
sent to the amplifier for each band from Q=20 (Narrow bandwidth, steep slope) to
Q=2 (Wide bandwidth, gentle slopes).
2.BASS FREQUENCY
This control sets the center frequency of the bass boost effect from 40Hz to 400Hz.
3.BASS LEVEL
This control sets the subwoofer level control.
