Lanzar HTG889, User Manual

Page: 7 / 18

www.Lanzar.com
7
CONTROL FUNCTIONS
1. RCA Input jacks
These RCA input jacks are for use with source units that have RCA or Line level
outputs. A source unit with a minimum level of 200mV is required for proper
operation. The use of high quality twisted pair cables is recommended to
decrease the possibility of radiated noise entering the system.
2. GAIN Control
The level control will match the amplifiers sensitivity to the source units signal
voltage. The Operating range is 200mV minimum to 6V maximum.
CAUTION: Do not run the amplifier in high volume for long time, otherwise the
loudspeakers will be damaged.
3. X-OVER (SELECT)
•
Full pass x-over switch
When the switch is in the " FuII " position, the full range is bypassed.
•
Low pass x-over switch
When the switch is in the " LPF " position, frequencies lower than the low pass
frequency setting are passed.
The frequency can be adjusted between 40Hz and 250Hz.
•
High pass x-over switch
When the switch is in the " HPF " position, frequencies higher than the high pass
frequency setting are passed.
The frequency is 40Hz-250Hz
•
Band Pass select switch
When the switch is in the " Band Pass " position, the band pass range is by
passed: 50Hz-2.5KHz.
4. Bass BOOST
The boost can be selected among 0dB, 6dB and 12dB.
5. Wireless BT Streaming
Wireless BT receiver.
Warning:
Do not connect a level control knob from other manufacturers to the Remote
Sub Level Control of any amplifier. Even though the connectors fit properly, the
control knob and connector pin positions may be different and the amplifier will
be damaged.