www.Lanzar.com
6
4. X-OVER
•
Full pass x-over switch
When the switch is in the "
Full
" position, the full range is bypassed.
•
Low pass x-over switch
When the switch is in the "
LPF
" position, frequencies lower than the low pass
frequency setting are passed. The frequency can be adjusted between 50Hz
and 250Hz.
•
High pass x-over switch
When the switch is in the "
HPF
" position, frequencies higher than the high
pass frequency setting are passed.
5.
Low pass x-over frequency control
This control is used to select the desired low pass x-over frequency.
The frequency can be adjusted between 50Hz and 250Hz.
6.
Bass BOOST
The boost can be selected among 0dB, 6dB and 12dB.
7.
REMOTE
Controls the subwoofer amplifier gain, from a remote location for ease of
adjustment during listening.
Warning:
Do not connect a level control knob from other manufacturers to the Remote
Sub Level Control of any amplifier. Even though the connectors fit properly, the
control knob and connector pin positions may be different and the amplifier
will be damaged.
8.
LED
Will illuminate
GREEN
to indicate the amplifier is on and operating normally,
and will be illuminate
RED
if the amplifier shuts down due to short circuit, DC
offset, or overheating detected by on board protection circuitry.
9.
Auxiliary outputs
The Auxiliary outputs offer LANZAR amplifiers easy, unlimited system expansion.
Route RCA's from the line out of the first amplifier to the line input of a second
amplifier when using a single source output.
