Lantronix
ION x6010 User Guide
33493 Rev. F
Page 57 of 261
4 Configuration
General
After the NID has been installed and access has been established, the device and its ports must be
configured to operate within your network. The configuration establishes operating characteristics of
the device and the ports associated with the NID.
Configurations can be done either by entering CLI commands (USB / Telnet) or through a Web interface.
For complete descriptions of all CLI commands, see “
Section 6: Command Line Interface (CLI)
Reference”.
The operating characteristics that can be defined for the NID are:
•
System setup
•
Features
–
Interface
(
AIS, TDM, Loopback modes)
•
Security
Note
: Lantronix recommends as a “best practice” to back up each SIC card’s configuration after it is fully
configured so that in the event of an error or hardware failure, the configuration can be easily and
rapidly restored.
