Lantronix
ION x6010 User Guide
33493 Rev. F
Page 210 of 261
DIP Switches and Jumper Settings
The x6010 NID has on-board components that can be used to configure device operation, typically at the
direction of a Lantronix technical support specialist. In most cases, the factory default settings provide
optimal configuration settings; however, DIP switch and/or jumper setting changes may be required for
operating mode changes or troubleshooting purposes.
Multi-position DIP switches allow configuring the
x6010 for varying network conditions. Use a small flat blade screwdriver or similar device to change DIP
switch settings for on-site configuration.
PCB Identification
This section covers the following PCBs (printed circuit boards):
1.
x6010
SIC – PCB 11354 Rev. 05 (this information is silkscreened at the top center of the PCB).
2.
x6010
NID – PCB 11354 Rev. A (this information is silkscreened at the top center of the PCB).
3.
x6010-10xx
– PCB 11381 Rev. A (this information is silkscreened at the top center of the PCB).
Note
: Do not change the configurable items except at the direction of a Lantronix technical support spe-
cialist.
C6010 PCB
PCB
: 11354 Rev. A (information is silkscreened at the top center of the PCB).
Figure 19: x6010 PCB Layout
