Configuration via Serial Mode or Telnet Port
WiBox™ User Guide
33
Remote Port
Set the remote TCP port number for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is
attempted.
To connect an ASCII terminal to a host using the unit for login purposes, use the
remote port number 23 (Internet standard port number for Telnet services).
Remote Port ( 0) ? _
Note:
This option is not displayed when Hostlist is enabled from the
ConnectMode prompt (see
Connect Mode
on page 26 for more information).
DisConnMode
Disconnect Mode (DisConnMode) determines the conditions under which the unit will
cause a network connection to terminate. The current value is displayed in
parentheses.
DisConnMode ( 0) ? _
In DisConnMode, modem_control_in either drops the connection or is ignored. The
following table displays the available input options:
Table 4-10. Disconnect Mode Options
Disconnect Mode Option
7
6
5
4
3
2
1
0
Disconnect with
modem_control_in drop
(6)
1
Ignore
modem_control_in
0
Telnet mode and terminal type
setup
(1)
1
Channel (port) password
(2)
1
Hard disconnect
(3)
0
Disable
hard
disconnect
1
State LED off with connection
(4)
1
Disconnect with EOT (^D)
(5)
1
(1) The WiBox sends the "Terminal Type" upon an outgoing connection.
(2) A password is required for a connection to the serial port from the network.
(3) The TCP connection closes even if the remote site does not acknowledge the disconnection.
(4) When there is a network connection to or from the serial port, the state LED turns off instead of blinking.
(5) When
Ctrl D
or Hex 04 is detected, the connection is dropped. Both Telnet mode and Disconnect with
EOT must be enabled for Disconnect with EOT to function properly.
Ctrl D
is only detected going from the
serial port to the network.
(6) When modem_control_in transitions from a high state to a low state, the network connection to or from the
serial port drops.
Flush Mode
The FlushMode (buffer flushing) parameter controls line handling and network buffers
with connection startup and disconnect.
FlushMode ( 0) ? _
Summary of Contents for WiBox
