SMxxTAT4Xx Quick Start Guide
33784 Rev. C
Page
3
of
4
Mode LED
Color
Function
PoE
Green
The RJ45 Port Status LEDs are displaying PoE powering status of each
port.
• SYS: Green Single Color
• Use Mode / Reset Button to change Mode
=> Light off: Changed Port LED to Other Mode
=> Green Light on: Change Port LED to PoE Mode
By pressing the Mode/Reset button for less than 2 seconds to change LED modes (Link/Act/Speed Mode or PoE
Mode) you can check the port status by reading the LED behaviors. See the Install Guide.
Mode/Reset button
: By pressing the Mode/Reset Button for certain period of time, you can:
Change Port Status
LED Mode
: To read the port status correctly in the two different modes (Link/Act/Speed mode or PoE mode).
Reset the Switch
: To reboot and get the switch back to the previous configuration settings saved.
Restore the Switch to Factory Defaults
: To restore the original factory default settings back to the switch.
Note
: Based on the table below, you can determine which task is being performed by reading the LED behaviors
while pressing the Mode/Reset button. Once the LED behaviors are correctly displayed, just release the button.
Mode/Reset button
:
Change LED Mode
: Press the button for 0~2 seconds; the SYS LED is On green; the LED status changes based on
the mode selected.
Reset Switch
: Press the button for 2~7 seconds; the SYS LED blinks green; all port status LEDs are Off.
Restore to Defaults
: Press the button for 7~12 seconds; the SYS LED blinks green; all port status LEDs stay On.
Back Panels
: The SM48TAT4XA-RP back panel contains the AC Power Connector(s), DC and AC LEDs, and a 2
nd
AC
Power Connector. The SM24TAT4XB back panel contains the AC Power Connector.
AC Power Connector
: The back panel provides the AC Power Connector marked AC Line: 100-200V 50-60Hz.
Installation
Package Contents
: Carefully unpack the switch from the packaging and verify you received one Switch, one AC
Power cord, four rubber feet, this document, two 19" Ear Rack Brackets, 8 Screws, 2 screws for power plate
cover, one DB9F to RJ45 Plug Console Cable, EPE for PSU (x2, -RP only), and one Insert card.
Mount Switch in a 19-inch Rack
:
1.
Attach the mounting brackets to both sides of the chassis. Insert screws and
tighten then with a screwdriver to secure the brackets.
2.
Place the switch on a rack shelf in the rack. Push it in
until the oval holes in the brackets align with the mounting holes in the rack posts.
3.
Attach the brackets to the
posts. Insert screws and tighten them.
Mount Switch on Desk or Shelf
:
1.
Verify that the workbench is sturdy and reliably grounded.
2
. Attach the four
adhesive rubber feet to the bottom of the switch.
Install SFP+ Modules
:.
1.
Position the SFP device at either installation slot, with the SFP label facing up on upper
SFP slots or down on lower SFP slots.
2.
Carefully slide the SFP device into the slot, aligning it with the internal
installation guides.
3.
Press firmly so that the SFP device is firmly seated.
4.
Attach an appropriate cable into the
SFP module port.
5.
Attach the other end of the cable to the other device.