SLC™ Console Manager User Guide
250
15: Command Reference
This chapter lists and describes all of the commands available on the SLC command line interface
(CLI) accessed by using Telnet, SSH, or a serial connection. In addition to the commands, this
chapter contains the following sections:
The following is an alphabetical listing of categories and within each category there is a list of
commands in alphabetical order:
Introduction to Commands
This section explains command syntax, command line help, and tips for using commands. For
more detailed information about commands, see
Command Line Interface on page 42
.
Command Syntax
Commands have the following syntax: <action> <category> <parameters>. The <action> value
can be one of the following: set, show, connect, diag, pccard, admin, or logout. The <category>
value is a group of related parameters that you can configure or view. Examples are ntp,
deviceport, and network.
Summary of Contents for SLC8
Page 1: ...Part Number 900 449 Revision J July 2014 SLC Console Manager User Guide SLC8 SLC16 SLC32 SLC48...
Page 95: ...8 Device Ports SLC Console Manager User Guide 95 Figure 8 4 Device Ports Settings...
Page 217: ...13 Maintenance SLC Console Manager User Guide 217 Figure 13 1 Maintenance Firmware Config...
