Lantronix SecureLinx SLK Series, User Manual

Page: 108 / 160

Using the OSD Interface to Configure the SLK
5-12 SecureLinx SLK Remote KVM User Guide
5 Write Community . Community that can write messages. (These display as
asterisks on the SLK8).
6 Trap Destination IP . IP address of SNMP management station (e.g., HP
OpenView).
7 Trap Destination Port Number . UDP port number of the SNMP management
station (default 162).
8 Enable SNMP Auth Traps . Enabling authentication traps generic to SNMP.
Enabled is the default.
9 Enable SNMP Notification (SLK8 only). Enabled by default.
Syslog Configuration
Syslog Configuration follows the Internet Engineering Task Force standard for han-
dling system events. Highlight Syslog to display choices for system logging
( Figure 5-11 ).
Figure 5-11. Syslog Configuration
1 Syslog Collector IP address . Type IP address of Syslog collector (daemon). The
default is no syslog .
2 Syslog facility . Numeric designation of message facility (default 16).
3 Log Mask . Hex code of severity. Pick any of 8 available codes listed (00–FF). For
information about converting binary numbers to hex format, see Chapter B, “Binary
to Hexadecimals’ . For more details about Syslog configuration, see Figure 4-26 .