Lantronix S3100 Series, Install Manual

Page: 8 / 19

Lantronix S3100 Install Guide
33581 Rev. C https://www.lantronix.com/ Page 8 of 19
Installation and Setup
General
This section describes how to install the S3100 and the procedures to access and initially set it up via
either a local serial interface (USB) or a remote Ethernet connection (Telnet session or Web interface).
Install the S3100
The S3100 is a standalone module. The following section describes how to install the S3100.
Caution : Failure to observe electrostatic discharge precautions when installing the S3100 could
result in damage or failure of the module.
Figure 2: Installation
1. Locate the S3100 in its final install location.
2. Install SFP Devices in PORT 1 and PORT 2. See “
Installing SFP Devices ” below.
3. Perform cabling from the S3100.
4. Make the Power Connection. See the “ Power Connection ” section below.