Lantronix
ION219-x Install Guide
33412 Rev. E
14
3 Installation
This chapter describes ION219-x cautions/warnings, site requirements, installation, and setup.
Cautions
Caution
: Install the ION219-x chassis so that the airflow around it is not restricted. Failure to observe this
caution could result in performance problems or damage to the contents of the chassis.
Caution
: Read the installation instructions before connecting the chassis to a power source. Failure to observe
this caution could result in poor performance or damage to the chassis and its SICs.
Caution
: Only trained and qualified personnel should install or replace the ION210-x chassis. Failure to observe
this caution could result in poor performance or damage to the chassis.
Safety Considerations
The following considerations will help to ensure your safety as well as protection of the chassis and its contents
from damage. This list does not contain all the potentially hazardous conditions that could exist at the
installation site, so exercise caution at all times.
•
Always unplug all power cords before installing or removing the chassis.
•
Keep the chassis area clear and dust free during and after installation.
•
Keep tools and chassis components away from walk areas.
•
DO NOT place containers containing liquid on top of the chassis.
Lifting Safety
Even though the ION219-x chassis weights less than twenty (20) pounds, use proper lifting to move the chassis
about. Keep your back straight and lift with your legs, not your back. If you need to bend down to lift the chassis,
bend at the knees, not at the waist to reduce potential for straining your lower-back muscles. See Figure 5
below.
Figure 5: Unsafe Lifting Techniques
Electrical Safety
Follow these basic guidelines when working with any electrical equipment:
•
Disconnect all power and external cables before installing or removing the chassis.
•
Do not work alone when potential hazard conditions exist.
•
Never assume that power has been disconnect from the circuit—always check.
•
Carefully examine your work area for possible hazards such as wet floors, ungrounded power extension
cables, and missing safety ground.
WARNING
: Do not work on the chassis, connect, or disconnect cables during a storm with lightning activity.
Failure to observe this warning could result in an electrical shock or death.
