Lantronix EMG 7500, User Manual

Page: 68 / 482

5: Quick Setup
EMG™ Edge Management Gateway User Guide 68
Figure 5-4 Home
Method #2 Quick Setup on the Command Line Interface
If the EMG does not have an IP address, you can connect a dumb terminal or a PC running a
terminal emulation program (VT100) to access the command line interface. (See Connecting
Terminals on page 47 .) If the unit has an IP address, you can use SSH or Telnet to connect to the
EMG unit.
By default, Telnet is disabled and SSH is enabled. To enable Telnet, use the
Services > SSH/Telnet/Logging (on page 148) .
To complete the command line interface Quick Setup script:
1. Do one of the following:
- With a serial terminal connection, power up, and when the command line displays, press
Enter .
- With a network connection, use an SSH client or Telnet program (if Telnet has been
enabled) to connect to
xx.xx.xx.xx
(the IP address in dot quad notation), and press
Enter . You should be at the login prompt.
2. Enter
sysadmin
as the user name and press Enter .
3. Enter the last 8 characters of the Device ID (for newly manufactured units that come installed
with 8.2.0.1 or later) or
PASS
as the password and press Enter . The first time you log in, the
Quick Setup script runs automatically. Normally, the command prompt displays.
Note: If the Device ID is not set, the default system password is the last 8 characters
of the serial number.