Lantronix EDS-MD Series, Command Reference Manual

Page: 656 / 738

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 656
tunnel <line>
Enters the tunnel level. <line> = number of the
tunnel line (serial port) to be configured.
write
Stores the current configuration in permanent
memory.
xoff char <control>
Sets the xoff character for use with software flow
control on this line. The character may be input as
text, control, decimal, or hex. A control character
has the form <control>C. A decimal value character
has the form \99. A hex value character has the
form 0xFF.
xon char <control>
Sets the xon character for use with software flow
control on this line. The character may be input as
text, control, decimal, or hex. A control character
has the form <control>C. A decimal value character
has the form \99. A hex value character has the
form 0xFF.
line 14 (config-mach10-line:14) level commands
clrscrn Clears the screen.
command delimiter <text> Sets the command delimiter.
content check interval <hours> Sets the firmware and configuration check interval.
default command delimiter Restores the command delimiter.
default content check interval
Restores the default firmware and configuration
check interval.
default status update interval Restores the default status update interval.
exit Exits to the config-mach10 level.
line <number> Change to line configuration level.
no project tag Restores the default Project Tag.
project tag <text> Sets the Project Tag.
show Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
state disable Disables command processing on line.
state enable Enables command processing on line.
status update interval <minutes> Sets the status update interval.
write
Stores the current configuration in permanent
memory.
line 15 (line:15) level commands
auto show statistics Continuously displays line statistics.
baud rate <bits per second>
Sets the line speed. <bits per second> = the speed.
Standard speeds include 1200, 2400, 4800, 9600,
19200, and so on.
clear line counters Sets the serial counters to zero.
clrscrn Clears the screen.
command mode always
Sets the current line to always be in command
mode.
command mode echo serial string disable
Disables user-defined serial boot string to be
echoed in the CLI.
command mode echo serial string enable
Enables user-defined serial boot string to be echoed
in the CLI.