Lantronix Com Port Redirector, User Manual

Page: 25 / 31

Configuring an MSS4 or MSS-VIA Device Server
This section describes how to configure Com Port Redirector for use with an
MSS4 or MSS-VIA device server.
Device Server Configuration
1. Assign an IP address to the device server before using Com Port Redirector.
2. Telnet into the device server and log in as the privileged user.
The command to login as the privileged user is set priv .
The default password is system .
3. Set the serial settings (baud rate, parity, flow control, data bits) to those of
the serial device attached to the Lantronix device server.
4. Issue the following commands at the Local_>> prompt. Replace the
n
with
the port number to which Com Port Redirector will connect. Press the Enter
key (shown as
<CR>
) after typing each command. The last command reboots
the unit.
change port n autostart disable <CR>
change port n access remote <CR>
init delay 0 <CR>
Redirector Configuration
1. Click the Start button in the Windows Taskbar, point to Programs , point to
Lantronix Redirector , and click Configuration . The Com Port Redirector
Configuration window appears (see Figure 4-6).
Figure 4-6. Com Port Redirector Configuration Window
2. Using the Redirect To drop-down list at the top of the Com Port Redirector
Configuration window, click a redirected com port.
Com Port Redirector™ User Guide 4-7