Monitor Mode
Troubleshooting
B-2
Monitor Mode Commands
The following commands are available in Monitor Mode. Many commands have an IP
address as an optional parameter (xxx.xxx.xxx.xxx). If the IP address is given, the
command is applied to another Device Server with that IP address. If no IP address is given,
the command is executed locally.
Note:
All commands must be given in capital letters, with blank spaces
between the parameters.
Table B-1: Monitor Mode Commands
Command
Command Name
Function
DL
Download
Download firmware to the
Device Server via
the serial port in hex format
VS x.x.x.x
Version
Query software header record (16 bytes) of
Device Server with IP address x.x.x.x
GC x.x.x.x
Get Configuration
Get configuration of Device Server with IP
address x.x.x.x as hex records (120 bytes)
SC x.x.x.x
Send Configuration
Set configuration of Device Server with IP
address x.x.x.x from hex records
PI x.x.x.x
Ping
Ping Device Server with IP address x.x.x.x to
check device status
AT
ARP Table
Show the
Device Server
’s ARP table entries
TT
TCP Connection
Table
Show all incoming and outgoing TCP connec-
tions
NC
Network Connection
Show the
Device Server
’s IP configuration
RS
Reset
Reset the
Device Server
’s power
SI
xxx.xxx.xxx.xxx:yyy.
yyy.yyy.yyy
Send/Set IP Address
Remotely assign an IP address to a Device Server,
where xxx.xxx.xxx.xxx is the IP address, and
yyyy.yyy.yyyy.yyy is the two-part identification
number at the bottom of the label, converted to
decimal and written twice.
QU
Quit
Exit diagnostics mode
G0, G1, ....,GE, GF
Get configuration
from memory page
Gets a memory page of configuration information
from the device.
S0, S1,...,SE
Set configuration to
memory page
Sets a memory page of configuration information
on the device.
