4
CTS UNIT WARNING
Please read before proceeding
This blind contains constant tension spring (CTS) units.
Take great care when pulling the cord out of the CTS! These are powerful units and can
cause damage or injury if misused!
Under NO circumstances must the cord be released to wind back into the CTS
unchecked. If this happens it WILL result in damage to the CTS and MAY ALSO result in
injury or damage to persons or property.
For your convenience and safety every CTS is provided with a locking point, which is
marked with an orange arrow. Pull the cord to rotate the spool inside the CTS until you
see the hole in the spool line up with the locking point. Insert a pin* through the locking
point into the spool to lock the CTS.
*for a locking pin you may use any metal shaft of 3-4mm diameter, e.g. small
screwdriver or screw. Ensure this does not fall inside the CTS unit.
To remove the locking pin, pull the cord tight to take the tension off the pin, lift the pin
out and allow any slack cord to SLOWLY feed back into the CTS.
In some cases your blind will be delivered with the CTS already locked with a screw
inserted into the locking point. DO NOT USE A SCREWDRIVER TO REMOVE THIS SCREW,
but remove it following the instructions above.
Locking Point
Tension Cord
NOTE
Summary of Contents for KuroLok RL
Page 1: ...FITTING INSTRUCTIONS 1...
