Shanghai Lansing Electronics Co., Ltd
Tel
：+86 021-69172728
Fax
：+86 021--69172728 ext 801
Web
E-mail：
Add: Building 6, No.
1028 Xinmiaosan Rd, Songjiang district Shanghai 201612
All rights reserved by Lansing, without the written authorization of the Lansing, any part thereof shall not be reproduced or transmitted in any form.
ZS100 Presicion Approach Path Indicator
ZS100
3 / 7
Flange Mounting Dimension:
The installation of PAPI lamp unit is fixed on the precast concrete base. Anchor the flange to
the base with the anchor bolt embedded in the base. If the expansion bolts are used, the size
must be greater than M10 x 120. The fixed position is shown in the figure.
Height Setting:
According to the requirements of the base height of the optical axis of PAPI system, set a
benchmark horizontal line to meet this height requirement before the lamp body. Loosen the
connection bolt of PAPI lamp, adjust the three adjusting screw on the lamp, make the light axis
of the front part of the lamp body align with the base line. Fine-tune the screw and observe the
horizontal blisters in the lamp until the lamp body level is up.
Wiring Diagram:
The PAPI system USES 6.6A ac constant current source. If The electricity environment is 110V.
First connect 110V power transformer(or manual voltage regulator), than there is a spin
button,so you get from 0 to 6.6A constant current source as you want.（The power cable should
be protected by metal hose.）
Internal wiring: