www.lanpro.com
Wireless - Router - LP-5420G
Steps for the installation of Lanpro LP-5420G Wireless Router.
•1 Foldable Screw type external antenna
•1 Router LP-5420G
•1 Power supply: 120 VAC input, 9 VAC @800Ma output
•1 (123) Basic Configuration Guide
•CD with manuals
Important remarks:
1
2
Figure 1
Please check box contentes first:
A
Please verify the mains voltaje to be in the 110-120 VAC ,
50 or 60Hz range.
The antenna must be connect before the router is turned on,
damage to the RF output stage can result if this remark is
not followed.
Figure 2
• Connect the router as follows:
-Connect the antenna to the router by screwing the connector
in place.
-Connect the network cable (568A or 568B Standard type
Patchcord ) from the DSL or Cable Modem from the ISP
(Internet Service Provider) to the WAN port on the back of
the router.
In case there are equipments that need to be connected
through a LAN connection, please use Standard patch cords
of the proper lenght of the 568A or 568B type to connect
to the computer and to the router through the LAN ports
available at the back of the router(1,2 3 and 4).
-Connect the power supply to the Router.
-Turn your Computer, Modem and Router
-Besides being installed as per the manufacter specifications.
Please verify the configuration of your wireless lan
connection(card or port) so that it obtains the IP address
and configuration automatically and without encryiption.
The Internet connection must be operative for this to work.
-The computer will automatically connect to the LanPro
WLAN unless there are other wlans available, in which case
you must select the LANPRO WLAN for connection. You can
verify the connection status looking at the icon shown on
the down right corner.
2
