www.lanpro.com
Wireless - Equipment - LP-1520ai WLAN AP - 123 Fast Intallation Guide
3
3.3
You should defi ne the functionality of your Radio. The possible modes are:
WDS:
in case you want to create a link between two or more points (PtP, PtmP).
WDS+Client:
case you want to create a link between two or more points (PtP, PtmP) and
accept Client type connections.
AP:
mode AP in which your equipment will serve to extend your wired network into a
wireless way.
Client:
Mode in which the AP will be a client of a wireless network, or to link two wired
networks, or as a client of a WLAN that is farther than a Wireless card can reach.
Figure 4
3.4
In the window shown in fi gure 4, you should disable the DHCP service and change the IP
address by selecting options
TCP/IP Settings
,
LAN Interface
, change the IP address as
per your convenience, select
DHCP
and
Disabled
. Please select
Apply Changes
in order
to activate them.
Figure 5
3.5
Please go to your NIC card properties as shown in fi gure 5 and confi gure the IP protocol as
shown in fi gure 6 so that it is in the equipment range. In this example, it should be in the
segment 192.168.1.x. where x must be different to 254 as it belongs to the LP-1520ai.
Figure 6
