Chapter 3. Bios Setup
23
User’s Manual
Primary Master / Primary Slave
Secondary Master / Secondary Slave: Press PgUp / <+> or PgDn / <-> to select Manual, None, Auto
type. Note that the specifications of your drive must match with the drive table. The hard disk will not
work properly if you enter improper information for this category. If your hard disk drive type is not
matched or listed, you can use Manual to define your own drive type manually.
If you select Manual, related information is asked to be entered to the following items. Enter the
information directly from the keyboard. This information should be provided in the documentation from
your hard disk vendor or the system manufacturer.
If the controller of HDD interface is SCSI, the selection shall be
[None]
If the controller of HDD interface is CD-ROM, the selection shall be
[None]
Here is a brief explanation of drive specifications:
!"
Access Mode: The settings are Auto, CHS, Large, LBA.
!"
Cylinder: Number of cylinders
!"
Head: Number of heads
!"
Precomp: Write precom
!"
Landing Zone: Landing Zone
!"
Sector: Number of sectors
Drive A and Drive B: Select the correct specifications for the diskette drive(s) installed in the computer.
None
No diskette drive installed
360K,
5.25 in
5-1/4 inch PC-type standard drive; 360 kilobyte capacity
1.2M,
5.25 in
5-1/4 inch AT-type high-density drive; 1.2 megabyte capacity
720K,
3.5 in
3-1/2 inch double-sided drive; 720 kilobyte capacity
1.44M, 3.5 in
3-1/2 inch double-sided drive; 1.44 megabyte capacity
2.88M, 3.5 in
3-1/2 inch double-sided drive; 2.88 megabyte capacity
Note: 1. Not Installed could be used as an option for diskless workstations..
2. Highlight the listing after each drive name and select the appropriate entry.
