Lanier LD225, Network Manual

Page: 42 / 150

Connecting and Setting Up
36
2
❖
Permit SSL / TLS Communication
Set the encrypted communication
of SSL/TLS.
• Ciphertext Only
• Ciphertext Priority
• Ciphertext / Clear Text
Note
❒
Default: Ciphertext Priority
❒
If you set to
[ Encryption Only ]
,
you need to install the server
authentification for the ma-
chine.
❖
Host Name
Specify the host name.
❖
Machine Name
Specify the machine name.
IEEE 1394
Preparation
You must install the optional IEEE
1394 interface board in the machine.
❖
IP Address
When you connect the machine to
a network using the IEEE 1394 in-
terface, you must configure the IP
address and subnet mask.
• Auto-Obtain (DHCP)
• Specify
When you select
[ Specify ]
, enter
the [ IP Address ] and [ Sub-net
Mask ]
as “xxx.xxx.xxx.xxx”(“x”
indicates a number).
• IP Address: 011.022.033.044
• Sub-net Mask:
000.000.000.000
Note
❒
Default: Auto-Obtain (DHCP)
❒
If you use the interface for Eth-
ernet and IEEE 1394 (IP over
1394) at the same time, settings
must be made carefully. See
p.133 “Using DHCP”
❒
When you use the IEEE 1394 in-
terface on a network, you can-
not use the Ethernet interface in
the same domain. To use both
interfaces in the same domain,
set different values for the
[ Sub-
net Mask ] .
❒
The physical address (EUI-64)
also appears.
❖
DDNS Configuration
You can specify the DDNS settings.
• Active
• Inactive
❖
Host Name
Specify the host name.
❖
Domain Name
Make settings for the domain name.
• Auto-Obtain (DHCP)
• Specify
• Domain Name
❖
WINS Configuration
You can specify the WINS server
settings.
• On
If [ On ] is selected, specify the
[ Primary WINS Server ] and [ Sec-
ondary WINS Server ] IP address as
“xxx.xxx.xxx.xxx” (“xxx” indi-
cates a number).
If DHCP is in use, specify the
[ Scope ID ] .
• Primary WINS Server
• Secondary WINS Server
• Scope ID
• Off
Limitation
❒
Enter [ Scope ID ] using up to 31
alphanumeric characters.
Note
❒
Default: Off