Lanier LD225, Network Manual

Page: 139 / 150

Using DHCP
133
6
Using DHCP
You can use the printer in a DHCP en-
vironment. You can also register the
printer NetBIOS name on a WINS
server when it is running.
If you connect an Ethernet interface
and IEEE 1394 (IP over 1394) interface
simultaneously, pay attention to the
following:
❖
When a static IP address is set for
both interfaces
• IP Address: If interface IP ad-
dresses overlap, the Ethernet in-
terface is selected.
• Subnet Mask: If interface subnet
masks overlap, the Ethernet in-
terface is selected.
• Gateway Address: The selected
value is applied.
Note
❒
Make the gateway address set-
ting inside the subnet set in the
interface.
❒
If a value is beyond the range of
the subnet selected by the inter-
face, the machine operates us-
ing "0.0.0.0".
❖
When obtaining addresses from the
DHCP server
• IP Address, Subnet Mask: you
can configure addresses as-
signed by a DHCP server.
Note
❒
If IP addresses overlap or the
same subnet IP addresses are
selected, the effective value is
assigned only to the priori-
tized interface.
❒
Ethernet has default interface
priority.
• AutoNet: A temporary IP ad-
dress starting with 169.254 and
not used on the network, is as-
signed to the prioritized interface.
Note
❒
Default interface priority is
IEEE 1394 (IP over 1394).
• Gateway Address, DNS Server
Address, and Domain Name:
You can configure the addresses
assigned by DHCP to the prior-
itized interface.
If the gateway address is beyond
the range of the subnet selected
for the interface, the machine op-
erates using "0.0.0.0".
Note
❒
Ethernet has default interface
priority.
❖
When there are static IP addresses
and addresses assigned by DHCP
• IP Address and subnet mask: if
a static IP address is the same as
an address assigned by DHCP,
or the static subnet mask ad-
dress and the subnet mask ad-
d r e s s a s s i g n e d b y D H C P
overlap, the machine uses the
static IP address interface.
Note
❒
The interface with the DHCP
setting is set by default.
• Gateway Address: oper-
ates using the address en-
tered manually.
Note
❒
If a static address is not selected,
or is set to 0.0.0.0, the interface
using the address assigned by
DHCP is used.