Lanier LD1110, Operating Instructions Manual

Page: 86 / 234

Copying
66
2
Changing the Number of Sets
You can change the number of copy sets during copying.
Important
❒
This function can be used only when the Sort function is turned on.
A
While “
Copying...
” is displayed, press the
{
Stop
}
key.
B
Press [ Change Quantity ] .
C
Enter the number of copy sets with the number keys, and then press the
{
q
}
key.
D
Press [ Continue ] .
Copying starts again.
Note
❒
The range of print copies enterable in step
C
depends on when the
{
Stop
}
key is pressed.
When memory is full
If the amount of data of the scanned originals exceeds the capacity of memory,
scanning is interrupted.
A
Press the
{
Start
}
key.
All scanned pages are copied, and data stored in memory are cleared.
B
Remove the copies, and then continue copying following the instructions
on the display.
Note
❒
The number of pages that can be stored in memory is about 2000 pages of
A4 size originals. It depends on the type of originals or memory settings.
❒
In Sort mode, you can complete scanning and copying by copying the
scanned pages stored in memory until it becomes full, and then scanning
and copying the remained originals.