Lanier FAX 3320L, Operating Instructions Manual

Page: 42 / 92

Faxing
36
2
Dialing
There are four main ways to dial a
number:
❖
Entering Numbers Directly
See p.36 “Entering Numbers Di-
rectly”
❖
Using Quick Dials:
See p.37 “Using Quick Dials”
❖
Using Speed Dials:
See p.38 “Using Speed Dials”
❖
Using Groups
See p.39 “Using Groups”
Entering Numbers Directly
Enter numbers directly using the
number keys on the right side of the
operation panel.
Note
❒
Maximum length of a fax number:
254 digits.
❒
You can insert pauses and tones in
a fax number. See p.37 “Pause”,
p.37 “Tone”
❒
A pause is shown as a “-” on the
display.
A
Make sure that the machine is in
standby display.
B
Set your original and select any
scan settings you require.
C
Enter the fax number with the
number keys.
The digits appear on the display as
you enter them.
Note
❒
If you make a mistake, press the
{
Clear/Stop
}
key and enter
again.
❒
If you wish to send this message
to more than one destination,
press the
{
OK
}
key, and then en-
ter the next destination.
D
Press the
{
Start
}
key.
-
Limitations when dialing with
the number keys
Fax numbers entered with the num-
ber keys are stored in internal memo-
ry (separate from memory for storing
original data). Therefore, using the
number keys, you cannot program 69
or more numbers for the following:
• Destinations specified in a Memo-
ry Transmission (including Polling
Reception)
• Destinations specified in a Group
For example, when 60 destinations
are registered in a Group with the
number keys, only 9 destinations can
be dialed for Memory Transmission
from the number keys.
StellaF16_combine_F-EN.book Page 36 Monday, January 22, 2007 6:59 PM