Lanier 5222, Operator'S Manual

Page: 28 / 102

Preparing for a Network Connection
3 - 6 Windows NT 4.0 Configuration
Inputting the Port Name for use with the TCP/IP Protocol
Enter the IP address of the Network Interface Board into the [IP address] box.
•
You can enter the host name or a domain name instead of an IP address into the [Host
Name] box.
•
You cannot use a host name that begins with “%%”.
•
When you use DHCP to assign IP addresses to Network Interface Boards, you can use a
printer name (Current Host name on the network configuration page) as the host name.
Inputting the Port Name for use with the NetBEUI Protocol
Print a configuration page, and confirm the Network path name.
•
For information on printing a configuration page, refer to the Operator Guide for your
printer.
Enter the printer's Network path name in form of “%%Computer name \Share name”. Do not enter
“\\” as head characters but “%%”.
8
Confirm the port name in the [Port Name] box, and click [Finish].
9
In the [Printer Ports] dialog, click [Close].
10
Confirm that the port name is displayed in the [Print to the following port(s)] box and ' mark
is inside the check box. Then click [OK].
•
Configuration is complete.
•
When you print, the printing procedure is no different. When you select the printer
configured here, the computer automatically uses Multi Direct Print.
Unistalling the Multi Direct Print Application
1
Open [Control Panel], and double click the [Add/Remove Programs] icon.
2
In the [Install/Uninstall] tab, select the [RICOH Multi Direct Print] by clicking it, and click
[Add/Remove].
3
After a confirmation message appears, click [Yes]. UninstallShield removes all of the
components of the Multi Direct Print application.
4
When the uninstallation is complete, restart your computer.