- 66 / 79 -
LANGER
EMV-Technik
DE-01728 Bannewitz
[email protected]
www.langer-emv.de
FLS 106 IC set / FLS 106 PCB set
Now insert the near-field probe into the probe sleeve of the probe holder and carefully tighten the
small screw on the outside of the probe sleeve by hand (Figure 92).
Figure 91: Probe sleeve removed from the magnetic
holder
Figure 92: Near-field probe with probe sleeve in the installed
state
The probe sleeve can also be removed from the holder as it is held magnetically so as to facilitate
assembly (section 10.8). Thanks to the rear bore, the probe sleeve can be returned to the
magnetic holder of the SH 01 and fastened in the correct position.
Finally check that the installed near-field probe moves smoothly in the Z-direction. This ensures
that the movement is stopped correctly if a collision occurs. Carefully pull the near-field probe up
by hand and check its smooth motion for this purpose.
Connecting a Near-Field Probe Directly to the FLS 106 IC Scanner
18.1.1
If operated without a pre-amplifier, the RF measuring cable has to be connected to the near-field
probe's measurement output and directly to "RF in" input on the scanner's Z-axis tower (Figure 93).
Figure 93: Direct connection of the near-field probe to the scanner
