- 59 / 79 -
LANGER
EMV-Technik
DE-01728 Bannewitz
[email protected]
www.langer-emv.de
FLS 106 IC set / FLS 106 PCB set
Installing an ICR Near-Field Microprobe
17
Laying the Connecting Cables
17.1
Unscrew the two screws of the cable holder on the rotary ring and place the upper part of the cable
holder on one side (see Figure 70).
Figure 70: Unscrewing the cable holder
Screw the short SMA-SMA RA measuring cable to the SMA coupling (Figure 71) and then lay it on
the rotary ring as shown in Figure 71.
Connect the SSMB-SSMB cable to the SSMB connector on the left side of the rotary unit below the
SMA coupling (Figure 73) and lay it on the rotary ring as shown in Figure 74.
Figure 71: Connecting the SMA-SMA measuring cable
Figure 72: SSMB connector on the rotary unit