P
URPLE
O
VEN
P
ROGRAMMING
EHS-C, ECCO-C, and
GCCO-C
O
PERATING
C
ODES
Below are codes, which will allow you to configure the display or aid in the operation, and
troubleshooting of the oven.
The readout must display
"
enter
"
before the computer will accept any programming code. If
the readout displays any other word, reset the computer by pressing and holding the
“R/C”
button until display reads
“
88888
”
then release. Display should then read
"
enter
"
.
The control allows for a 3-second delay between each button push, if a delay of longer than 3
seconds has occurred, the code will not be accepted and the programming code must be re-
entered. The instructions call for pressing exactly what is shown under "PRESS".
O
PERATING
C
ODE
D
ESCRIPTIONS
•
OPERATIONAL
PRESS
Recall time remaining on a shelf
Shelf
Cancel a shelf timer
R/C, R/C, Shelf
•
DISPLAY MODES
PRESS
Countdown timer display
R/C, 4, 8, 4, 8, 4, 8
Shelf in use display
R/C, 0, 9, 0, 9, 0, 9
Internal oven temperature display
R/C, 8, 7, 8, 7, 8, 7
•
PROGRAMMING
PRESS
Enter programming mode
R/C, 1, 6, 2, 7, 3, 8
Recall an existing product program
R/C, R/C, P (Product programmed)
Erase a product program
R/C, 1, 6, 2, 7, 3, 8 (P) (000)
Model identification
R/C, D, C, D, C, D, C
Fan Setting ( HI or Both)
R/C, E, D, C, B, A, 1(high), 2 (both)
Program download (Contact Factory)
R/C, A, B, C, D, E, P
•
MAINTENANCE
PRESS
Actual oven temperature
R/C, 3, 4, 5, 6, 7, 8
Return to ENTER
R/C
•
SHELF COMPENSATION
PRESS
Enter shelf compensation mode
R/C, C, B, C, B, C, B
Set shelf compensations
(I.E.) A, 2, 3, A
Return to ENTER
R/C
Page 3 of 4
Purple Programming.doc
