1
2
8
9
10
11
13
3
12
Controls the boost and cut of the high-frequency response of the pre-amplifier.
Sets the overall listening level of the amplifier.
RCA/Phono connections provided for connecting an external sound source such as; CD players, MP3 players, Minidisc etc.
This socket provides a balanced low-impedance output-signal from the pre-amplifier taken before the Master Volume but after
any tone correction, used for direct-injection of the amplifier signal to a mixing-desk or additional power-amplifier.
Send and return sockets are provided for connecting external effects-units. You can also use the Send socket as a line out if
you wish.
Indicates power is connected and the amplifier is switched on.
(Always switch off and disconnect power cord when not in use)
Main power on/off switch.
5
Normal and High inputs are provided for connection of bass guitars. High output basses, either Active or Passive should be
connected via the High socket. Low output basses should be connected using the normal input. High output basses may also
be placed in the Normal input if pre-amp overloading is desired.
This control is used to set the level of gain present in the pre-amp. The higher the level of gain, the more the signal will clip
producing distortion. The Gain control should be used in conjunction with the Volume control to produce the desired
signal characteristics.
Engages and disengages the on-board compressor, this compresses the input-signal giving a punchier sound. In association
with the compressor are two LEDs, one indicating that the compressor is engaged and one indicating the compressor is
active. The amount of compression is controlled by the Gain control. The higher the setting the more compression. With
most guitars compression will begin at about 5-6 on the control. It is possible to have the compressor engaged but it only be
active during certain periods of playing - typically the most dynamic sections.
Controls the boost and cut of the low-frequency response of the pre-amplifier.
Selects the mid-frequencies (200Hz to 2KHz) to be cut or boosted in conjunction with the paramid level control
To access low mid-frequencies turn the frequency control anticlockwise, to access higher mid frequencies turn the frequency
control clockwise.
8
6
1
Page 6 /12
Page 7 /12
2
3
4
6
7
8
9
10
11
12
13
FRONT PANEL CONTROLS
Laney
OPERATING INSTRUCTIONS
Laney
OPERATING INSTRUCTIONS
4
5
6
7
Summary of Contents for Richter Bass RB3
Page 1: ...USER MANUAL RB3...
Page 3: ...Page 3 12...
