Laney LV300H, User Manual, Page: 11 / 12

Page 10 /12
Laney
OPERATING INSTRUCTIONS
General Notes
Amplifier connection:
In order
to avoid damage, it is advisable
to establish and follow a
pattern for turning on and
off your equipment. With
all system parts connected,
turn on source equipment,
tape decks, cd players,
mixers, effects processors etc.
SAMPLE SYSTEM
8 Ohms
Link
Model
RB115
Power Rating 300W Program
Model
RB115
Power Rating 300W Program
Serial Number: Serial Number:
Input
Laney
Power To The Music
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
8 Ohms
Link
Model
RB115
Power Rating 300W Program
Model
RB115
Power Rating 300W Program
Serial Number: Serial Number:
Input
Laney
Power To The Music
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
SAMPLE
LV412A
BEFORE turning on your guitar amplifier. Many products have large transient surges at turn on
and off which can cause damage to your speakers. By turning on your guitar amplifier LAST and
making sure its Volume controls are set to minimum any transients from other
equipment will not reach your loudspeakers. Wait until all system parts have stabilised;
usually a couple of seconds. Similarly when turning off your system always turn down
the Volume controls on your guitar amplifier and then turn off its power before turning
off other equipment.
Cables: never use shielded or microphone cable for any speaker connections as this will not be
substantial enough to handle the amplifier load and could cause damage to your amplifier
system.
Caution: These professional loudspeaker systems are capable of generating very high sound
pressure levels. Use care with placement and operation to avoid exposure to excessive levels
that can cause permanent hearing damage. (Refer to guidelines on page 2)
Servicing: The user should not attempt to service these products. Refer all servicing to
qualified service personnel.
Supply Voltage ~100V, ~120V, ~220V, ~230V, ~240V 50/60Hz Factory Option
Mains Fuse ~220V>~240V = T2A L. ~100>~120V = T5A L
Power Consumption 300W
Output Power Rating 120W
Features Rugged construction
ECC83 Tube Drive Stage
Twin loudspeaker sockets
(Minimum 4 Ohm Impedance)
FX Loop (Nominal 750mV Level)
Footswitchable Yes, Channels and Reverb (LVFS3 included)
Reverb Yes
EQ Both channels contain separate Passive Bass, Middle and Treble
Clean Bright Switch
Independent VScoop switches for Drive 1+2
Input Impedance 1MOhm/47pF
Size 250*667*248 (H*W*D)
Unit Weight 12.4 Kg
Packing Weight 13.6 Kg
VTS - V Tone Shift Technology
Page 11 /12
Laney
OPERATING INSTRUCTIONS
SPECIFICATIONS
This product conforms to the requirements of the following European Regulations, Directives & Rules:-
CE Mark (93/68/EEC), Low Voltage (72/23/EEC), EMC (93/68/EEC),
RoHS (EU2002/95/EC), WEEE (EU2002/96/EC)
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal
household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the WEEE
(Waste Electrical and Electronic Equipment) directive applicable in your country.