1
2
3
4
6
7
8
9
10
12
The Mic input is designed for low impedance microphones, it is a stereo jack socket so will work equally well with
microphones that are balanced or unbalanced.
The Line In socket is designed for line level signals such as those obtained from keyboards, sound modules and sounds cards.
Both mic and line sockets may be used at the same time.
This gain control allows you to adjust the audio level of instruments connected to the Channel 1 Mic and Line In sockets.
RCA Phono socket for the connection of line level equipment like CD Players etc.
1/4” Jack socket designed to accept any line level signals from equipment such as keyboards, sound modules, CD/MP3 players
and sounds cards. Both CD and line in sockets may be used at the same time.
This gain control allow you to adjust the level of instruments connected to the Channel 2 CD In and Line In sockets.
Low/Bass frequencies can be boosted or cut by this control such as bass guitar, kick drums, deep vocals and keys below
middle C on a keyboard.
High/Treble frequencies can boosted or cut by this control. Sources that fall in this range are cymbals, soprano vocals and
keys above top C on a keyboard.
The AH50 has a built in spring line reverb, the level of reverb effect is determined by this control. (Affects both channels)
1
Page 6 /12
2
3
FRONT PANEL CONTROLS
Laney
OPERATING INSTRUCTIONS
11
13
7
4
8
9
Control the overall sound level from the amplifier.
By connecting a Laney FS1 footswitch here you can remotely switch the reverb on / off. This is a useful facility as it allows you
to switch the reverb off between songs during a gig.
This socket provides a balanced low-impedance output-signal from the pre-amplifier taken before the Master Volume but after
any tone correction, used for direct-injection of the amplifier signal to a mixing-desk or additional power-amplifier.
This is for the connection of headphones for private listening, connecting headphones here disconnects the internal
loudspeaker.
Indicates power is connected and the amplifier is switched on.
(Always switch off and disconnect power cord when not in use)
Main power on/off switch.
10
Page 7 /12
11
12
13
Laney
OPERATING INSTRUCTIONS
5
15
5
6
14
15
16
18
16
17
Power inlet socket. Connect to your power source. Make sure the specified voltage is correct for your country!
This drawer contains the main safety fuse for the unit.
USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL.
The mains fuse ratings are detailed in the specs section at the rear of this manual.
Serial Number and model of your unit.
17
18
14
All manuals and user guides at all-guides.com
