Laney AH4X4 User Manual Download Page 7

Page: 7 / 16

FX and Outputs

8. Bluetooth

: Keep things tidy and lose the wire by connecting your souce via a Bluetooth capable device.

To enable the onboard Bluetooth receiver, press the ON button. Whilst searching, the adjacent Pair led will
flash fast. Once a connection has been established, the Pair led will flash slowly. The range for a Bluetooth
connection is approximately 10M.

If you aren’t using Bluetooth, de-press the Bluetooth ON switch. This will reduce power

consumption and prevent accidental pairing.

Both Bluetooth and AUX inputs can be used simultaneously.

(Please see the manufacturers documentation for your Bluetooth device for connection

information).

9. FX TYPE:

This control determines the amount of Delay or Reverb to be applied to CH1 and CH2 if FX

switch (5) is enabled. The delay/reverb length will be increased as you turn the control away from the
centre position for both modes.

Don't forget to enable CH1/CH2 FX switches and enable Master FX ON, if you want them to

be routed through the FX processor.

10. MASTER FX ON:

Quickly switch FX on and off using this control. The adjacent LED with illuminate

when the FX section is active. The FX can also be switched via a Laney FS1 foot-switch.

Master FX switch (10) must be On for FX remote to function.

11. FX LEVEL:

Fine tune the amount of FX applied to the signal using this control.

2. MODE SWITCH:

This dual function switch allows you to select one of four pre-defined EQ curves

allowing you to adjust the overall feel of your music. To toggle from one to the next simply press the switch
momentarily. An adjacent led will clearly indicate what’s selected. The EQ setting will be stored in memory,
ready for use next time.

Flat:

General purpose EQ setting.

Bass:

An increase in the low frequency content of your audio.

Loud:

An increase in both low and high frequencies, with a slight mid cut.

Vocal:

Decreases the amount of bass and emphasises the vocal content. Also ideal for outdoors

If you press and hold the Mode switch (for around a second) the EQ leds reconfigure to indicate the
available/remaining battery life. The battery meter will display for as long as you hold the switch.

For the most reliable battery level check, there shouldn’t be any sound from the speakers. This

could be done by turning down input level, disconnecting/muting input signals or by turning the
Master Volume (13) to minimum.

13. VOLUME:

This is the master volume level control. It controls the level from the onboard speakers,

Link Out and Sub Out. Always start with this turned to minimum.

TIP