Landoll VT Plus 7410, Operator'S Manual

Page: 62 / 104

3-30 F-561-0818
ASSEMBLY INSTRUCTIONS
Conditioner Reel Spring
Installation (Option)
NOTE
Refer to Conditioner Single Reel Installation shown in
Figure 3-24 for single reel installation or Conditioner
Double Reel Installation shown in Figure 3-25 for double
reel installation.
1. Slide the adjustment pin through the rear plates of
center and wing frames, secure with (2) 2-1/2 snap
rings.
2. Assemble the 1-8 x 9 adj bolt through adjustment pin
on frame, 1" lock washer, (2) 1-8 hex nuts, and 17"
heavy spring assembly.
3. Install 1-1/2” flange bearing into reel arm. Slide in
1-1/2” pivot bushing.
4. Attach reel arm to upper hole on rear center or wing
frame or double mount using 1-8 x 6-1/2 hex head
cap screw and hex lock nut.
5. Assemble 17" heavy spring assembly to reel arm
using 1" pivot pin, and 5/16 x 1-1/2” spring slotted
pins. Set pin centers to 21" dimension as shown in
Figure 3-24.

WARNING
6. Attach single reel/gang bar assembly to reel arms
using gang bar mount plate, 3/4-10 x 6 hex head cap
screws and double hex lock nuts as shown in
Figure
3-24 . Refer to pages 2-6 thru 2-17 for single reel
gang bar placement locations.
7. Attach double reel/gang bar assembly to reel arms
using gang bar mount plate, (2) clamp tubes, (4)
spring torsion rubber, secure with 3/4-10 x 8-1/2 hex
head cap screws and double hex lock nuts as shown
in
Figure 3-25 . Refer to pages 2-18 thru 2-23 for
double reel gang bar placement locations.
8. Install (2) clamp tubes on front and back of double
gang bar, secure with 1/2-13 x 5-1/2 hex cap screws
and 1-2 lock nuts.
Refer to pages 2-18 thru 2-23 for
clamp tube locations. Each set (2 total) should be slid
against gangbar mount plate on outside of inner wing
arm assemblies.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, lift, pull hitch, or reel/gang bar
assembly manually. Use a hoist or a forklift to
move these parts into position.