OPERATION
3-5
Parking Pin (Pick-up Seeders Only)
WARNING
Figure 3-5: Parking Pin
When Hooking Up the Seeders:
1.
Attach seeder to the tractor.
2.
Remove the Klik pin, pull the parking pin into the
outer position, replace the Klik pin.
and 3-6.
When Unhooking the Seeder
:
1.
Remove the Klik pin, push in the parking pin, replace
the Klik pin.
See Figures 3-5 and 3-7.
2.
Disconnect the tractor from seeder.
Figure 3-6: Hooking Pick-Up Seeder
Figure 3-7: Unhooking Pick-Up Seeder
To prevent the implement from tipping backward
on the frame, disengage parking pin only when
the seeder is fully attached to the tractor. Be sure
to observe the following sequences.
Klik Pin
Parking
Pin
./,.3,1
3$5.,1*3,1
5($552//(5
)/2$76
./,.3,1
3$5.,1*3,1
5($552//(5
/2&.('
Summary of Contents for SSB-10
