WALKING TANDEM INSTRUCTIONS
1-3
Bushing and Set Screw
Installation
7.
Install set screws to verify they go completely through
the hole and can contact the bushing.
8.
Clean/blow out all contaminants and apply some
lubricant to the new bushing and it should be able to
be pushed in by hand. If it takes much more force
than this pull it out and see if there are any
obstructions.
CAUTION
9.
Once bushing is installed, center it up on the walking
beam so that neither side hangs out too far to
interfere with the thrust washers.
10. Install set screws and tighten down to contact the
bushing and snug them up. Do not over tighten as
this will crush the bushing
Due to the seal being on the outer edge, the
bushing cannot be forced very hard or damage
will occur to the seal.
