Landoll EHP, Operator'S Manual

Page: 16 / 54

2-8 F-1153-2308
COMPONENT OVERVIEW
TABLE OF CONTENTS
Remote Charging Light
The green remote charging light is located to the left of the
charging port. This green multi pattern light will turn on to
alert the operator that the charging cycle is in progress. It
will display three different patterns, to reflect the current
state of charge within the batteries.
Status Bar & Display Panel
The charger’s status bar and display panel indicators will
show fault/error/maintenance codes, battery charging
status and AC power connection.
Figure 2-8: Charger
Contactor
DANGER
DANGER
The contactor is located on the streetside right interior of
the enclosure, to the right of the motor behind the vent and
front covers. It is a high current switch that is electrically
activated to connect and disconnect the batteries positive
feed from the system. Requires complex electrical system
troubleshooting and repair. It is highly recommended to
REMOTE CHARGING LIGHT INDICATIONS
Slow Green
Battery LOW State of Charge
Light Flash: ON 1 sec, OFF 0.2 sec,
repeating
Fast Green
Battery HIGH State of Charge
Light Flash: ON 0.4 sec, OFF 0.1 sec,
repeating
Solid Green
Battery Full State of Charge
Solid Light ON
DISPLAY PANEL
CHARGE OUTPUT
SEGMENT DISPLAY
WRENCH BUTTON
USB DATA PORT
STATUS BAR
AC POWER
CHARGING
FAULT
CHARGER REMOVED
FOR CLARITY
Failure to comply may lead to death, severe injury
or damage to equipment. Requires complex
electrical system troubleshooting and repair. It is
highly recommended to contact the Landoll
Trailer Service Department at Landoll.com or
phone 800-446-5175 / 888-522-3634.
1. SHOCK HAZARD - Batteries are in a parallel
circuit, this increases the system’s amps,
capacity and energy. Use proper insulated
tools and procedures when working with
batteries.
2. SHOCK HAZARD - DO NOT touch terminals,
Use proper insulated tools and procedures
when working with batteries.
STATUS BAR & DISPLAY PANEL INDICATORS
Solid Red = Charger fault; See the display
panel for details.
Flashing Amber = External error condition -
Caution; See the display panel for details.
Flashing Green = USB Port active.
Solid Green = Safe to remove USP flash drive.
Breathing Green = High state of charge.
Solid Green = Charge complete.
Breathing Green = Low state of charge.
Solid Green = High state of charge.
Solid Blue = AC power available.
Change Algorithm.
Display Software Settings.
Power Off Charge on DC only.
Solid Yellow = Output active.
Flashing Yellow = Externally Disabled
F # # # = Failt Code#.
E # # # = Error Code#.
P # # # = Algorithm#.
U-S-B = USB port active.
C # # # = Checksum, contact Delta-Q.
S # # # = Software Ver, contact Delta-Q.