COMPONENT OVERVIEW
2-3
Gear Icon
The green gear icon is located to the right of the battery
status bar. The purpose of the gear icon is to
communicate hydraulic pump status to the operator while
viewing the display module. This should be visible while
the key switch is in the “ON” position and the hydraulic
pump is working normally. It also activates the exterior
pump-on light to alert the operator, the hydraulic pump
status while working around equipment,
Pump Pressure
The pump pressure reading is located on the left side of
the screen, below the voltage gauge. It shows the current
pump pressure being supplied to the system. Idle
pressure is programmed to run at 370 psi. Working
pressure will fluctuate depending on load requirements,
LS Pressure
The LS pressure reading is located on the left side of the
screen, below the pump pressure. It shows the current
hydraulic pressure at the main hydraulic manifold. This
pressure will fluctuate as pressure flow through the
manifold,
Run Hours
The run hour meter is located in the left bottom corner of
the screen. It shows the total time the motor has ran. This
will only be reset when the motor is replaced,
Keypad Functions
The keypad is located on the bottom of the display frame.
It consists of 5 programmed buttons used to transition
through the different screens available,
Figure 2-2: Display Panel, Main Screen
KEYPAD BUTTONS (LEFT TO RIGHT)
1
Home Button: Changes Screens, Main
Screen or Battery Status Screen.
2
Screen Back Lighting, Bright or Dark
3
Not programmed at this time.
4
Not programmed at this time.
5
Not programmed at this time.
E 1/2 F
I I I I I
210
130
50
-30
290
370
450
CURRENT
27
A
VOLTAGE
54.7
V
48
44
40
52
56
60
MOTOR
111
F
104
32
-40
176
248
320
Run Hours
0.22 h
13%
GEAR ICON
MOTOR VOLTAGE
MOTOR TEMPERATURE
MOTOR CURRENT
CHARGE BATTERY INDICATOR
RUN HOURS
LS PORT - MAIN HYDRAULIC MANIFOLD
HYDRAULIC PUMP PRESSURE
1
2
3
4
5
KEYPAD BUTTONS
DL
DL ICON
PUMP 375 PSI
LS 40 PSI
Summary of Contents for EHP
