Landoll Brillion Turfmaker II Series, Operator'S Manual

Page: 58 / 114

2-40 9K998-2306
TABLE OF CONTENTS
S-Tine Tire Track Remover
Kit - Optional
IMPORTANT
S-Tines should not be operated any deeper than
necessary to remove Tractor Tire Tracks. Wet soil will
stick to the Front Roller Wheels. As the S-Tine draft
load is increased the S-Tines may deflect back and
make contact with the Front Roller and break.
NOTE
S-Tine Tire Track Remover Kit includes six S-Tines.
Additional S-Tines can be purchased and installed or
fewer S-Tines can be used.
S-Tine Brackets and S-Tines should be positioned per
application. Use
Figure 2-68 only as a reference.
1. Center and position the S-Tine Brackets in
relationship with the center of the Drawbar or 3-PT
Hitch to the front of the Seeder Frame Tube.
See
Figure 2-68. Secure S-Tine Brackets to the Seeder
Frame Tube with 1/2-13 x 7-1/2 x 4-1/2 U-Bolts, Lock
Washers and Nuts.
See Figure 2-67.
2. Center the Tooth Tube between the S-Tine Brackets
and attach with Straps, 1/2-13 x 6 Bolts, Lock
Washers and Nuts.
3. Attach the S-Tines onto the Tooth Tube in the desired
position to cover the Tractor Tire Tracks with Clamps,
7/16-14 x 3-1/2 Carriage Bolts and Locknuts.
4. Assemble the Points to the S-Tines. The suggested
pattern is to assemble the Reversible Point onto the
center S-Tine and a Duck Foot Point on the S-Tine on
either side of the center S-Tine with 3/8-16 x 1-3/4
Plow Bolt and Flanged Locknut.
See Figure 2-66.
NOTE
Scraper Kit can be used with the S-Tine Tire Track
Remover. Attach the outer Scraper Bracket Angle to the
S-Tine Bracket Tube. Outer Scraper Kit Brackets with the
4-Hole Plate are not used.
See Figure 2-62. It may be
necessary to adjust the Scraper Brackets on the Scraper
Assembly for proper positioning of the Scrapers to the
Front Roller Wheels.
Figure 2-66: S-Tine Point Position
Tractor Tire Depression
Tooth Tube
S-Tine
Duck Foot Point
Reversible
Point
Duck Foot Point