Landoll Brillion SSB, Operator'S Manual

Page: 36 / 102

2-14 1P480rev0718
ASSEMBLY
Electric Clutch Kit - Optional
IMPORTANT
At no time use high pressure water or air to clean the
Electric Clutch as damage could occur.
1. Verify that the Electric Clutch has 1/8” clearance
between the Clutch Housing and Rubber Bumper
Stop. Improper clearance may prevent the Clutch
from engaging or disengaging.
See Figure 2-18.
2. Connect Clutch Harness to Clutch Lead and route
along Frame and Drawbar/3Pt Hitch. Secure to
Frame and Drawbar/3Pt Hitch or with Hydraulic
Hoses and Warning Lamp Harness with Tie Wraps
and Adhesive Mounting Plates.
See Figure 2-19.
3. Install Clutch Switch on Tractor in a convenient
location with the Hook and Loop included or other
type of mount (not included).
4. Connect Harness to power source and secure.
5. Check Electric Clutch Operation. The Electric Clutch
will disengage when power is applied. (Clutch will
make a clicking sound). Set Seeder on the ground
and drive a short distance while turning Toggle
Switch to “Seed” and “No Seed”. The Seed Shaft will
stop rotating when Toggle Switch is turned to “No
Seed” Position.
6. Turn Toggle Switch to “Seed” Position when Seeder
is not used to shut off power to prevent possible
overheating of Clutch Coil.
Electric Clutch Attributes:
• The Electric Clutch is controlled by a Toggle Switch
on the Clutch Switch Box that is mounted to the
Tractor.
• The Electric Clutch is disengaged when power (12
Volts) is applied. If there is a power failure or
electrical problem, the Seeder will continue to
operate, so the machine must be raised to stop
seeding.
• Seed Shafts will not rotate when the machine is
backed up.
• The Clutch Switch Box contains a 5 Amp Time-Delay
Fuse.
• The Electric Clutch must be disengaged (power
applied) when Seed Shafts are turned manually for
Calibration
.
Figure 2-18: Clutch Clearance
Figure 2-19: Clutch Harness
*DS
%XPSHU%ROW
5XEEHU%XPSHU
6WRS
(OHFWULF
&OXWFK
&OXWFK/HDG
(OHFWULF
&OXWFK
&OXWFK+DUQHVV
+\RVHV