2-2
F-948R0
ASSEMBLY
Drawbar Installation
Bring the rear of the Drawbar into position between the
Frame Hitch Plates at the center of the Frame. Place two
1-1/4 x 1-7/8 x 14 ga Machinery Bushings on each side
between the Drawbar and the Frame Hitch Plates.
. Attach the Drawbar to the Frame with 1-8 x
9-1/2 Bolt and Locknut.
The locknut should be tightened
so that the frame is free to pivot on the Drawbar.
Attach the Brace to the inside of the Frame Brace Lug.
Slide Flat Washer onto 1-8 X 5-1/2 Bolt and insert bolt
through Brace. Add another Flat Washer and slide Bolt
through Frame Brace Lug. Add Flat Washers and
Locknut, tighten so that the Frame is free to pivot on the
Drawbar.
Repeat for the opposite side.
and
.
Rotate the braces so they are in line and against the
Drawbar. Insert 5/8-11 x 8
Bolts through the holes in the
braces above and below the Drawbar and secure with
Locknuts.
These Locknuts should be tightened securely
(110 Ft-Lbs
).
Attach Transport Lock Pin and Lynch Pin into Locked
Position on the frame.
Mount the Hose Support to the Drawbar using 5/8-11 x 2
Bolt, Washer and Locknut.
Attach the Jack to the Drawbar using the pin provided.
Attach the Manual Storage Canister using two 4-1/2
Hose Clamps.
Figure 2-2: Drawbar to Hitch Plates
Figure 2-3: Frame Brace Lugs
Attach the Manual Storage Canister using two 4-1/2”
Hose Clamps.
Attach the hydraulic cylinder base end to the Drawbar lug
with vendor supplied hardware. Attach rod end to the
frame lug with 1 x 10-1/8 pin.
Place a
Flat Washer on each side and secure with 5/16 x 2 Roll
Pin. It may be necessary to extend the cylinder rod or
raise the frame slightly to make this connection. Be sure
to bend the cotter pins so that the cylinder mounting pins
cannot disengage.
&\OLQGHU
)UDPH
'UDZEDU
'R1RW
RYHUWLJKWHQ
'UDZEDUPXVWEH
IUHHWRSLYRW
0DFKLQHU\
%XVKLQJ
/RFDWLRQ
7UDQVSRUW/RFN
3LQLQ/RFNHG3RVLWLRQ
3)72S3LYRW
Do Not
over tighten, Brace
must be free to pivot
Pivot Hardware
Frame
Brace