4-2
9D990-2401
MAINTENANCE
Fasteners
Before operating your Brillion machine, check all
hardware for tightness. Use the Tightening Torque Table
as a guide.
After a few hours of use, check entire machine and tighten
any loose nuts or bolts. Daily or periodic checks should be
made thereafter.
When replacing bolts, be sure to use fasteners of equal
grade.
Tires
Recommended tire sizes are 7.6 x 15-6 Ply Tire and
should be inflated to 40 PSI.
When Re-Installing the Wheel Nuts tighten to 50
foot-pounds using the sequence in
Then
tighten to full torque of 85-100 Ft-lbs.
Figure 4-1: Stud Tightening Sequence
Points
NOTE
When replacing or reversing point, change all points at the
same time so that they will have the same operating
depth. If some shanks have worn points, or points of a
different design, the Chisel Plow will not operate
efficiently.
Lubrication Maintenance
•
Wheel Hub Lubrication should be performed at the
beginning of every season of use. Check the wheel
bearings periodically for excessive end play.
•
Grease Wheel Hubs every 50 hours.
•
Grease Spring Shank Clamp every 10 Hours to
prevent seizure.
Figure 4-2: Wheel Hub Lubrication
Figure 4-3: Spring Shank Lubrication
50
Hrs
Repack
Annually
10
Hrs
Summary of Contents for Brillion CPPR2-5
