Landoll Brillion CPPR2-5, Operator And Parts Manual

Page: 18 / 48

2-8 9D990-2401
ASSEMBLY
TABLE OF CONTENTS INDEX
Gauge Wheel Assembly
1. Set the Frame on a level surface with the Shanks
mounted.
2. Attach the Hub and Spindle Assembly to the Arm
Weldment.
3. Clamp the Arm Weldment to the side bar of the Frame
with 5/8 U-Bolts, Washer and Nuts. See Figure 2-10.
4. Position the Arm Weldment assembly about 1/3 of the
way back from the front of the Frame. To adjust the
Gauge Wheels for depth, loosen the two U-Bolts but
do not remove the nuts.
5. Set Gauge Wheels to desired height so that both
Wheels are set at the same depth. The distance from
the bottom of the tire to the tip of the Shank will be the
approximate working depth of the Shank.
6. Tighten the U-Bolts securely and check periodically
for looseness.
Figure 2-10: Gauge Wheel Installation
U-Bolt,5/8-11 x
5-5/8 x 4-11/16
Plate
Nut,5/8-11
Washer,5/8
Bolt,3/8-16 x 3
Arm Weldment
Locknut,3/8-16
Hub and Spindle
Assembly
Wheel and Tire
Wheel Bolt,
1/2-20 x 1
FRONT
Frame