Landoll Brillion Alfalfa SS108, Operator'S Manual

Page: 40 / 92

2-24 9K713-0522
ASSEMBLY
TABLE OF CONTENTS
Console w/Clutch Control
Installation - Optional
Mount Console with Clutch Control on Tractor. See
Figure 2-35.
1. Route Console Harness with 9-Pin Connector to the
Seeder Harness.
2. Attach 3-Pin Power Plug to tractor.
3. Secure Console Harness with tie wraps.
4. Route Seeder Harness along front frame of seeder.
Ensure Connector labeled "Electric Clutch Power" is
on the left side.
5. On left side connect plug labeled “Electric Clutch
Power” to the Electric Clutch lead. If you do not have
an Electric Clutch seal the plug end using a 2-Pin
Shroud and Cavity Plug to protect it from the
environment.
See Figure 2-32.
6. Connect plug labeled “Left Front Seed Shaft Sensor”
to the left front Seed Shaft Sensor. Seal the plug end
using a 3-Pin Tower and Cavity Plugs to protect it
from the environment.
7. Repeat for the right side.
8. Secure all Harnesses and Wires with cable tie and tie
wraps.
Figure 2-32: Console w/Clutch Control Electrical Schematic
Labled
Electric Clutch
Power
Seed Shaft
Sensor
Clutch included
with Seeder
Labled
Left Rear Seed
Shaft Sensor
Labled
Left Front Seed
Shaft Sensor
Labled
Right Front Seed
Shaft Sensor
Labled
Right Rear Seed
Shaft Sensor
Cavity
Plug
3-Pin
Tower
3-Pin Tower
Cavity Plug
Power Plug
Seeder Console
with Clutch Control
Seed Shaft
Sensor
9-Pin
Connector
Seeder
Harness