4-4
F-581-R1
CALIBRATION AND PROGRAMMING
Log Functions
Figure 4-7: Main Inputs Screen
Main Inputs
The “MAIN INPUTS” screen shot provides monitored
parameters for the Plus 1 functions. See Figure 4-7.
Below is provided a definitions list for forklift
parameters: See Figure 4-7.
ECU
checks the status of the following;
A. Drive Pedal within acceptable range.
B. Fan coil.
C. Drive Pedal position.
D. Steer Calibration within tolerance.
E. Steer pot within acceptable range.
F. FWD EDC coil.
G. REV EDC coil.
H. Forward direction switch.
I. Reverse direction switch.
J. Drive pedal switch.
1.
0,3-CP_BRAKE_SW
– On when stop pedal is
depressed, Off when stop pedal is in neutral position.
This signal is provided by a pressure transducer.
2.
0,3-CP_Enable
– On once ECM completes pre start
checks successfully, Off when fault is present.
3.
0,3-CP_Lift_Spool_Pot
– Displays pot wiper
voltage.
4.
0,3-CP_J1939_MAP_KPA
– Not used “for naturally
aspirated”.
5.
0,3-CP_J1939_BaromKPA
- Not used “for naturally
aspirated”.
6.
0,3-CP_PctLoad_Avg
– Displays an average of the
percent load transmitted from the GFI Engine
controller.
7.
0,3-CP_Load_PID
– Displays the output of the PID
loop, Max load vs. Engine load.
8.
0,3-CP_Steer_mV
– Pot wiper voltage.
9.
0,3-CP_Steer_Pot
- Pot setting.
Summary of Contents for Bendi B40i4
