Landoll 9630 Series, Operator'S Manual, Page: 101 / 148

ASSEMBLY INSTRUCTIONS
3-11
Figure 3-6: Lighting and SMV Bracket Installation
Lighting and SMV Bracket
Installation (Prior to August,
2013) (Non-LED Lights)
1. Attach red lamp w/ brake and reflector mount
assembly to each tail light mount using 1/4-20 x 1-1/4
hex head cap screws and hex lock nuts
(See
Figures 3-5 and 3-6.) Note that the reflector mount
assembly includes the reflector mount, red reflector,
and orange stripe.
2. Install enhanced lighting module to bottom of right
tail light mount using #8-32 x 1/2 slot pan head
screws and hex nut.
3. Install left and right tail light mount assemblies to the
rear frame using 5/8-11 x 3-11/16 x 6-3/8 u-bolts and
hex lock nuts
(For placement of tail light brackets,
see Figure 2-9.)
4. Attach single amber lamp to each light mount using
1/4-20 x 1 hex head cap screws and hex lock nuts.
5. Install left and right light mount assemblies onto the
frame using 1/2-13 x 2-1/8 x 3-1/4 u-bolts and hex
lock nuts
(For placement of light brackets, see
Figure 2-9)
6. Connect warning light harnesses to lights and
enhanced lighting module.
7. Install the SMV mounting bracket close to the center
of machine on rear frame member using 5/8-11 x
4-11/16 x 4-1/2 u-bolts and hex lock nuts so that
bracket is snug around frame member
(See
Figure 3-5.)
8. Attach SMV emblem to SMV mounting bracket using
1/4-20 x 1 hex head cap screws and hex lock nuts.
NOTE: IF REPAIRING OR REPLACING THE 7 PIN
CONNECTOR, MATCH THE LETTERS AT THE
BACK OF THE HARNESS TO THE 7 PIN CONNECTOR
AS SHOWN. THE COLOR OF THE WIRE JACKET
DOES NOT NECESSARILY MATCH THE COLOR
MARKING OF THE 7 PIN CONNECTOR.
4-PIN
TOWER
7-PIN
CONNECTION
C
A
B
D
BRN. 6
GRN. 5
YEL. 3
GRND. 1
WIRING CHART
#1 WHITE
#2 BLACK
#3 YELLOW
#6 BROWN
#5 GREEN
#4 RED
#7 BLUE
FACING 7-PIN CONNECTOR
9630-electrical op p2